Looking for 2020 Streetglide torque specs for front axel nut, Pinch bolt and Brake caliper mounting bolts.

Harley front caliper bolt torque

Gear shaft nut torque: 150 ft-lbs. minecraft bedrock development) Primary cover bolts: 14-21 ft lbs 2. new projects miami

use these numbers as they are straight out of the service manual. Bjsorensen said: I was wondering what the torque specs for the front axle bolt is and also for the caliper bolts. . 79 in Instructions: Do not lubricate bolt.

.

.

.

Harley’s checklist says check for proper front axle nut torque.

Drain Screw i01760a.

.

. Torque to lighter specification and check for leakage, increasing torque only to stop leakage without exceeding. . 7 gallons.

. Manual also states use new torx screws when mounting rotors/discs as bigbadal stated. No problem I need torque spec's front brake rotor,front axle nut and front brake caliper bolts 2005 Harley davidson ultra classic.

Divide the in/lbs number by 12 to give your reading in ft/lbs.
A Microsoft logo is seen in Los Angeles, California U.S. 23/02/2024. REUTERS/Lucy Nicholson

Reply.

If you are working on the rear caliper, you can place a. Those specs are in the owner's manual that came with the motorcycle.

class=" fc-falcon">• P/N 230-12094 Banjo Bolt, M10-1. 20.

Step 2 – Brake caliper replacement Front.

Those specs are in the owner's manual that came with the motorcycle. See more.

Axle Pinch Bolts.

Nothing in my toolbox fits.

caliper torque 28-38 ft lbs,front axle nut torque60-65 ft lbs.

. Discussion Starter · #19 · Sep 11, 2017. What size are the bolts that hold the the front brake caliper to the fork leg. 22 roadglide ST.

The process is similar for the front and the back, but the only difference is the room you will have to work. Bjsorensen said: I was wondering what the torque specs for the front axle bolt is and also for the caliper bolts. Gear shaft nut torque: 150 ft-lbs. tif Figure 5.

.

vlucdog. What size are the bolts that hold the the front brake caliper to the fork leg. After removing the bolts, pull the caliper up off the rotor and then out.